South African Class Experimental 5 2-8-2

This article is about one of two different Cape Government Railways locomotive types to be designated "9th Class". For the other CGR 9th Class locomotive, see South African Class Experimental 4 2-8-2.

CGR 9th Class 2-8-2 1906
South African Class Experimental 5 2-8-2

300px CGR 9th Class no. 840, c. 1906 SAR Class Experimental 5 no. 948

Type and origin Power type Steam Designer Cape Government Railways (H.M. Beatty) Builder Kitson and Company Serial number 4341 Model CGR 9th Class Build date 1906 Total produced 1

Specifications Configuration 2-8-2 (Mikado) Driver axle 3rd coupled axle Gauge 3 ft 6 in (1,067 mm) Cape gauge Leading dia Coupled dia 54 in (1,372 mm) Trailing dia 33 in (838 mm) Tender wheels as built 34 in (864 mm) retyred Wheelbase  • Engine 29 ft 9 in (9,068 mm)  • Coupled 14 ft 7 in (4,445 mm)  • Tender 16 ft 1 in (4,902 mm)  • Tender bogie 4 ft 7 in (1,397 mm) Wheel spacing (Assymetrical) 1-2: 5 ft 1 in (1,549 mm) 2-3: 4 ft 8 in (1,422 mm) 3-4: 4 ft 10 in (1,473 mm) Length:  • Over couplers Height 12 ft 10 in (3,912 mm) Frame type Bar Axle load  • Leading  • 1st coupled  • 2nd coupled  • 3rd coupled  • 4th coupled  • Trailing  • Tender bogie Bogie 1: Bogie 2:  • Tender axle Adhesive weight Loco weight Tender weight Loco & tender weight Tender type XF2 (2-axle bogies) Fuel type Coal Fuel capacity 7 LT 10 cwt (7.6 t) Water cap Boiler:  • Pitch 7 ft 3 in (2,210 mm)  • Diameter  • Tube plates 17 ft (5,182 mm)  • Small tubes 203:  • Firebox type Round-top Boiler pressure 180 psi (1,241 kPa) Safety valve Ramsbottom Firegrate area 33.1 sq ft (3.08 m2) Heating surface 2,162.5 sq ft (200.90 m2)  • Tubes 2,032.8 sq ft (188.85 m2)  • Firebox 129.7 sq ft (12.05 m2) Cylinders Two Cylinder size 20 in (508 mm) bore 28 in (711 mm) stroke Valve gear Stephenson Couplers Bell link-and-pin

Performance figures Tractive effort 28,000 lbf (120 kN) @ 75%

Career Operators Cape Government Railways South African Railways Class CGR 9th Class Mikado SAR Class Experimental 5 Number in class 1 Numbers CGR 840, SAR 948 Delivered 1906 First run 1906 Withdrawn 1929

The 2nd & 3rd coupled axles had flangeless wheels

The South African Railways Class Experimental 5 2-8-2 of 1906 was a steam locomotive from the pre-Union era in the Cape of Good Hope.

In 1906, the Cape Government Railways placed a single experimental 9th Class steam locomotive with a 2-8-2 Mikado type wheel arrangement in service. In 1912, when this locomotive was assimilated into the South African Railways, it was renumbered and designated Class Experimental 5. The design was never repeated.

Manufacturer

The Cape 9th Class Mikado type steam locomotive was designed by H.M. Beatty, the Locomotive Superintendent of the Cape Government Railways (CGR) from 1896 to 1910. It was a larger version of his 9th Class of 1903, which was also built with a bar frame and Stephenson’s Link valve gear and which also used saturated steam. The locomotive was delivered with a Type XF2 tender by Kitson and Company in 1906 and was numbered 840.

Characteristics

At the time, it was considered as a big advance in motive power. It was a large locomotive and, on the CGR, it was exceeded in size only by the experimental Kitson-Meyer 0-6-0+0-6-0 locomotive, which had entered service in 1903.

File:H.M. Beatty.jpg

H.M. Beatty

With this locomotive, Beatty overcame his aversion to boiler centre lines which exceeded twice the Cape gauge width of 3 feet 6 inches (1,067 millimetres) above the railhead, by raising the boiler pitch to 7 feet 3 inches (2,210 millimetres). The locomotive was larger than its predecessor 9th Class of 1903 in all respects, with a longer boiler which had a bigger girth, larger diameter pistons with a longer stroke, larger diameter driving wheels, a larger firebox, and a tender with a larger fuel and water capacity. The design was, however, never repeated and the Cape 9th Class Mikado remained unique.

Service

Cape Government Railways

The locomotive was placed in service on the Western System, working on the mainline between Touws River and Prince Albert Road in the Karoo, until it was determined by the Civil Department of the CGR that the engine was too heavy for the rails and bridges on this section. It was then transferred to the section between Beaufort West and De Aar, where heavier rail was in use.

South African Railways

When the Union of South Africa was established on 31 May 1910, the three Colonial government railways (CGR, Natal Government Railways and Central South African Railways) were united under a single administration to control and administer the railways, ports and harbours of the Union. Although the South African Railways and Harbours came into existence in 1910, the actual classification and renumbering of all the rolling stock of the three constituent railways required careful planning and was only implemented with effect from 1 January 1912.

In 1912 the locomotive was designated Class Experimental 5 and renumbered to 948 on the South African Railways. It was later transferred to Braamfontein, where it remained until it was withdrawn from service and scrapped in 1929.